Family-owned · Trusted by Port St. Lucie homeowners
4.7★(348+ Verified Reviews)
BBB
A+ Rated & Accredited
Angi
Super Service / Top Rated
Thumbtack
Top Pro
Nextdoor
Neighborhood Favorite
Licensed & Insured
Local Technicians
Licensed KitchenAid refrigerator repair in Stuart. We chart built-in refrigeration sensors, dual evaporators, and ice/water valves on premium cabinets on the truck — call (772) 501-9870 to dispatch.
Call directly or submit the request form below for same-day dispatch. Same-day openings are common when you call in the morning. Stuart is a core part of the regular Treasure Coast route from the Port St. Lucie hub. $75 diagnostic, credited 100% toward approved same-visit repair.
Live Dispatch Radar
Live coverage across Tradition, St. Lucie West, Sandpiper Bay, and the greater Treasure Coast — track Mobile Unit #1 and confirm your ZIP before you request service.
Live unit status
Mobile Unit #1 — Dispatched
Current area: Port St. Lucie
⚡ Status: Dispatched & On Call
Pan the radar to your neighborhood (34953, 34986, 34983…).
🚐 Mobile Unit #1 · Port St. Lucie
Local conditions
Symptom, local cause, and how we test — each card stays short for mobile scanning.
Estuary humidity and periodic salt-tinged air around Downtown Stuart loads KitchenAid condenser fins until inverters look dead. We brush coils and meter fans first.
In Stuart, moderate municipal water with a slow mineral load scales ice maker fill tubes and dual water valves without affecting the sealed system. When refrigerator cooling drops, the issue typically traces back to heavy condenser dust loads or a failed adaptive defrost thermistor.
Lightning along the Roosevelt Bridge and Kanner Highway storm corridor chatters KitchenAid relays and sags inverter DC rails. Storm resets are board-and-rail paths before any compressor quote.
Common failures
Dual evaporator / three-way valve path
KitchenAid French-door and column boxes need frost mapping before a compressor quote. Built-in access is planned on dispatch, not improvised after millwork is off.
Fill tube heater / inlet valve
Fill tubes freeze in humid Sandpiper Bay and river-adjacent kitchens the same way they do on Whirlpool. We test the valve and heater, not the entire door.
Display / main control harness
Storm-damaged UIs between Jensen Beach and Fort Pierce are metered at the harness so a $30 thermistor is not sold as a $400 board.
Field diagnostics
KitchenAid refrigeration — especially built-ins — is an airflow and thermistor job first. We will not quote a compressor through a dirty toe-kick.
Platform: Built-in / Whirlpool architecture
| Component | Test | Spec / pass line |
|---|---|---|
| Cabinet / evaporator thermistor | Resistance at ~77°F (25°C) ambient | Typically 5–12 kΩ (confirm against the model chart before a board swap) |
| Condenser fan | Running current at the lower grille with the coil vacuumed | Nameplate ±15%; locked-rotor or zero spin is a fan, not a compressor |
| Sealed-system sanity | Frost map + suction-line temperature after 10 minutes | Even sheet on the evaporator; a starved inlet is leak/restriction work, not a thermistor |
Interactive bench check
Ohm, kΩ, µF, or voltage — not an error-code lookup. Pick the component, enter what the meter shows, and we will tell you whether the control board is being lied to.
Cabinet / evaporator thermistor. Typically 5–12 kΩ at ~77°F (25°C); confirm against the model chart before a board swap
Power off. Thermistors are low-voltage NTC beads — do not inject 120 VAC.
Enter the meter reading
Spec: Typically 5–12 kΩ at ~77°F (25°C); confirm against the model chart before a board swap
KitchenAid built-ins hide the condenser. We pull the grille and prove airflow before a sealed-system number on a $3k cabinet.
Keep / repair: Compressor windings in spec, no oil stain at joints, and the complaint is fan, damper, defrost, or a water valve
Replace when: Confirmed leak or restriction on a unit older than ~10 years when the sealed-system quote crosses half of a comparable replacement
Hyper-local conditions
Stuart is Martin County municipal water and river humidity. We pull the coil on every garage fridge near the Roosevelt Bridge before a sealed-system sentence. Storm-dead dryers get a fuse check. North River Shores tickets need the bridge note or the van does not fit. For KitchenAid refrigerators here: Ice-maker fill tubes and dual valves take the mineral; cooling complaints still start at the condenser and the defrost thermistor. Dishwasher Calrod heaters and washer inlet screens on river-side homes; ice valves clog later than in Tradition but sooner than a brand-new PSL east-side install. Access: Port Salerno is booked as Stuart (34997), not a separate city. Downtown alleys and river-side driveways need a place to leave the van that is not blocking a cafe lot.
City of Stuart municipal supply — moderate hardness, not Palm City well sediment and not Tradition wellfield calcium
Slow mineral load that shows up on original equipment in downtown and East Stuart houses, not overnight scale
Dishwasher Calrod heaters and washer inlet screens on river-side homes; ice valves clog later than in Tradition but sooner than a brand-new PSL east-side install
St. Lucie River estuary humidity — downtown, North River Shores, and the Roosevelt Bridge corridor, not just the 'waterfront lot'
Garage and carport refrigerators near the river pick up the coastal Martin corrosion pattern without being on A1A
Storm corridor welds oven and washer boards; a dryer that dies after a cell is almost always the thermal fuse
Downtown Stuart, East Stuart, North River Shores, Port Salerno, Kanner Highway subdivisions
North River Shores private bridges have posted weight limits — we note them before sending a stocked van
Port Salerno is booked as Stuart (34997), not a separate city. Downtown alleys and river-side driveways need a place to leave the van that is not blocking a cafe lot
On this stop
In Stuart we treat KitchenAid refrigerators as a Built-in / Whirlpool architecture job, not a generic appliance call. First meter check: Cabinet / evaporator thermistor — Resistance at ~77°F (25°C) ambient (Typically 5–12 kΩ (confirm against the model chart before a board swap)). Built-in airflow is not a cheap condenser clean: KitchenAid built-ins hide the condenser. We pull the grille and prove airflow before a sealed-system number on a $3k cabinet. Local water is City of Stuart municipal supply — moderate hardness, not Palm City well sediment and not Tradition wellfield calcium. Slow mineral load that shows up on original equipment in downtown and East Stuart houses, not overnight scale. Install reality: Garage and carport refrigerators near the river pick up the coastal Martin corrosion pattern without being on A1A Storm corridor welds oven and washer boards; a dryer that dies after a cell is almost always the thermal fuse. Triage on this platform (8–12 years typical Florida life): repair when Compressor windings in spec, no oil stain at joints, and the complaint is fan, damper, defrost, or a water valve Replace when Confirmed leak or restriction on a unit older than ~10 years when the sealed-system quote crosses half of a comparable replacement.
Field dispatch
Structured truck notes — symptom, meter path, parts. Not a star rating.
Verified local repair · North River Shores — private-bridge note on the ticket
Verified local repair · inverter not replaced
Verified local repair · Downtown Stuart river-adjacent garage
Verified local repair · linear compressor left installed
KitchenAid refrigerator calls in Stuart follow US-1, Kanner Highway, and the Roosevelt Bridge corridor, then Port Salerno and East Stuart when the window allows a downtown grouping.
View our full range of Stuart appliance repair services, or explore our dedicated diagnostic hubs for refrigerator repair and KitchenAid appliance repair. For official municipal context, see the City of Stuart official website. Advertised coverage stays inside Port St. Lucie, Tradition, St. Lucie West, Torino, PGA Village, Jensen Beach, Stuart, Fort Pierce, White City, Hutchinson Island, Palm City, and Lakewood Park — we do not book Hobe Sound or Vero Beach from these pages.
FAQ · Pay on-site
No. No online prepayment — pay on-site upon diagnostic/approval. The in-home diagnostic is $75, credited 100% toward an approved repair on the same visit. A second appliance on the same stop is $35.
We offer same-day and next-day dispatch throughout Stuart and surrounding neighborhoods, particularly for calls received before 2:00 PM. Our dispatch team coordinates directly with you to provide a tight arrival window.
Port St. Lucie Appliance Repair holds a 4.7/5 aggregate rating from 348+ Treasure Coast customer reviews.
Live Google reviews
Pulled from our Google Business Profile (4.7/5 from 348+ Verified Reviews). If Google is briefly unavailable, we show recent local feedback instead — same shop, same number (772) 501-9870.